Residual Risks; Important Safety Instructions For All Battery Chargers - DeWalt DCT418 Traducido De Las Instrucciones Originales

EN GLI SH
Detection Through Special Surface
Conditions
WALLPAPER
The hand-held radar scanner will function normally
on walls covered with wallpaper or fabric, unless the
materials are metallic foil, contain metallic fibers or
are still wet after application.
PLASTER AND LATH
Due to the uneven thickness of plaster, it may be
difficult to locate studs. It may be easier to identify
the metal nail heads in the studs. If the plaster is
reinforced with wire mesh, the hand-held radar
scanner will not be able to reliably detect objects
behind it.
TEXTURED OR ACOUSTICAL WALLS AND CEILINGS
When scanning a wall or ceiling with an uneven
surface, place thin cardboard on the surface and
scan over the cardboard.
WOOD FLOORING, WOOD SUB-FLOORING AND DRYWALL
OVER PLYWOOD
Due to the thickness of these materials, it may
be difficult to detect a wood stud or joist. It may
be easier to detect the metal nails that hold the
materials to the stud or joist.
CARPETING
The hand-held radar scanner cannot detect studs or
joists through carpeting. It may be easier to detect
the metal nails that hold the materials to the stud or
joist.
NOTE: Sensing depth and accuracy can vary due to
moisture, content of the materials, wall texture and
paint.

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Risk of personal injury due to prolonged use.
– Risk of personal injury due to unintentional
contact with current-carrying parts during the
work process.
Markings on Hand-Held Radar
Scanner
The following pictograms are shown on the hand-
held radar scanner:
Read instruction manual before use.
40
DATE CODE POSITION
The date code, which also includes the year of
manufacture, is printed into the housing surface that
forms the mounting joint between tool and battery.
Example:
2012 XX XX
Year of Manufacture
Important Safety Instructions for All
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual
contains important safety and operating instruc tions
for the DCB100 and DCB105 battery chargers.
• Before using charger, read all instructions and
cautionary markings on charger, battery pack,
and product using battery pack.
WARNING: Shock hazard. Do not allow
any liquid to get inside charger. Electric
shock may result.
CAUTION: Burn hazard. To reduce
the risk of injury, charge only D
rechargeable batteries. Other types of
batteries may burst causing personal
injury and damage.
CAUTION: Children should be
supervised to ensure that they do not
play with the appliance.
NOTICE: Under certain conditions, with
the charger plugged in to the power
supply, the charger can be shorted by
foreign material. Foreign materials of
a conductive nature such as, but not
limited to, grinding dust, metal chips,
steel wool, aluminum foil, or any buildup
of metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when
there is no battery pack in the cavity.
Unplug charger before attempting to
clean.
• DO NOT attempt to charge the battery pack
with any chargers other than the ones in
this manual. The charger and battery pack are
specifically designed to work together.
• These chargers are not intended for
any uses other than charging D
rechargeable batteries. Any other uses
may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce risk
of damage to electric plug and cord.
WALT
E
WALT
E