DeWalt DCT418 Traducido De Las Instrucciones Originales página 46

EN GLI SH
ASSEMBLY AND ADJUSTMENTS
WARNING: Always turn the hand-held
radar scanner off before inserting or
removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Hand-Held
Radar Scanner (fi g. 3)
NOTE: Make sure your battery pack is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (a) with the rails inside the
handle.
2. Slide it firmly into place until you hear the lock
snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (l) and firmly pull the
battery pack out of the hand-held radar scanner
handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
Proper Hand Position
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
Proper hand position requires one hand on the
handle (b).
Getting Started (fi g. 2)
Power On/Off
To turn on the hand-held radar scanner, press the
power on/off button (g) and hold for 0.5 seconds.
To turn off the hand-held radar scanner, press the
power on/off button (g) and hold for 2 seconds.
The hand-held radar scanner will also power off
automatically after 15 minutes of inactivity.
INITIAL SETUP
Press the power button (g) to turn on the hand-held
radar scanner.
44
The first time the hand-held radar scanner is
powered on, it will prompt to select a language.
1. Press the right/down arrow button (j) or left/up
arrow button (h) to select the desired language.
WALT battery
E
2. Press the OK button (i) to confirm selection.
BASIC OPERATION
The hand-held radar scanner identifies objects
behind a wall surface in three steps.
1. Place unit on wall.
2. Pre-scan Mapping: Move in a straight line
across wall surface.
3. Display scanned objects: Reverse scan direction
to display identified objects.
The pre-scan data mapping process can begin
in any direction. The hand-held radar scanner will
automatically change to displaying objects when the
initial scan direction is reversed.
The hand-held radar scanner can be used either
horizontally or vertically.
During the first pass over the wall surface, the pre-
scan data mapping occurs. The hand-held radar
scanner will automatically sense and calibrate for all
objects below the wall surface. When the direction
of scan is reversed, the hand-held radar scanner will
display the objects identified.
ENGLISH ITALIANO
ESPAÑOL NEDERLANDS
FRANÇAIS POLSKI
DEUTSCH Pycc