DeWalt DC010 Manual De Instrucciones página 17

Instructions for use
Always observe the safety instructions
and applicable regulations.
Radio operation
Volume control (fig. A)
• Turn the volume control (1) to the desired level.
Mode selection (fig. A & C)
• Turn the mode selector (2) to the desired mode:
AM, FM or FM stereo. The power light (9) will be lit.
• To switch the radio off, turn the mode selector to
the setting off.
Station selector (fig. A & C)
• Turn the station selector (3) to the desired
frequency setting, which is indicated by the
pointer (10).
In the FM stereo mode, the stereo indicator (8) will
be lit in case of stereo reception.
Power source
The tool runs either on mains power or battery
power. The tool will switch between AC (mains) and
DC (battery) power automatically.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Cleaning
• Unplug the tool from the mains and remove the
battery pack before cleaning the housing with a
soft cloth.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
where it will be disposed of in an environmentally
safe way.
Rechargeable battery pack
A long life battery pack must be recharged when it
fails to produce sufficient power on jobs which were
easily done before. At the end of its technical life,
discard it with due care for our environment:
• Run the battery pack down completely,
then remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
E N G L I S H
WALT repair agent
E
17