Orkli OKSOL Manual De Instalación página 19

2. Place lower support and intermediate spacers:
Doing this, the proper distance between supports will be set:
Detail of the lower assembly:
Detail of the lateral assembly, the support profiles are inserted in the base profiles:
3. Attach the base to the structure:
The support structure allows the assembly of OKSOL at inclinations of 20º, 30º, 40º and 50º, depending
on the anchorage position chosen for the rear support profiles.
In this step it is recommended to pre-install the screws without tightening them, so that
the profiles can be rotated.
EN
19