Troubleshooting - GYS NOMAD POWER 20 Manual De Instrucciones

FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
ANOMALIES, CAUSES, REMÈDES

TROUBLESHOOTING

No response while pressing the ON/
1
OFF button
«Error» light ON on the jumper
2
cable.
«Error» light flashes red + alarm
3
beep.
The device is warm whilst connected
4
to a laptop.
8
NOMAD POWER 20
1 - Plug the auxiliary cable (not supplied) to the 12V 12A NOMAD POWER
port.
2 - Plug the auxiliary cable (not supplied) to your 12V device.
3 - Press the power button.
not supplied
Press the power button for 3 seconds to activate the LED.
Briefly press the button to switch lighting modes (4 available modes: normal,
flash, SOS and OFF).
CAUSES
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
Polarity reversal
Short-circuit
Clamps have been left connected to the battery.
-
REMEDIES
Charge the product (see page 6).
Charge the product.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Remove the 2 clamps from the car battery in order to protect the device.
Remove laptop's battery or unplug the NOMAD POWER from the laptop for 5
minutes and plug it back again.
EN