OPERATION
4.4 PARALLEL TRIMMING FOR PUSH TRIMMERS
trimming setting:
1. Loosen the T-handle located on the back of the trimmer, below the engine (Figure 4.1).
2. Hold the handle bar/axle assembly and move the body assembly. The pivot point is directly below the center of the
engine.
3. Tighten the T-handle loosened in step 1.
4.
position.
5. Tighten the T-handle and resume regular trimming or mowing.
Pivot Point
8
Figure 4.1, Adjusting the Trimmer
WHEELED TRIMMER
T-Handle