Echo WT-1610 Guia De Inicio Rapido

Subject: Pro-line Head Kit
Kit: 99944400000
Model: WT-1610, WT-1610T,
WT-1610HSP
Before inspecting or servicing any part of this machine, shut off power source, disconnect spark plug wire from spark plug
and make sure all moving parts have come to a complete stop.
SAFETY
Your safety and the safety of others is important.
Valuable safety messages are provided in these
instructions. Please carefully read and obey these
messages.
1. Improper use or abuse of the Trimmer Line Holder
can result in serious injury.
2. Do not install or operate the Trimmer Line Holder
on the Wheeled Trimmer with any safety device
or guard removed, incorrectly installed, changed,
inoperative or in poor condition.
3. Do not use bent, fractured, dulled or damaged
Trimmer Line Holders.
4. Do not operate the Wheeled Trimmer in the vicinity
of bystanders. Keep a minimum distance of 100
feet away from people and pets.
5. Do not allow children or an inexperienced operator
to use the Wheeled Trimmer.
6. Wear safety glasses at all times during operation.
7. Inspect the surrounding area thoroughly before
use. Remove all foreign objects before operation.
8. Avoid hitting stones, wire, bottles, rocks, glass,
cans, metal of any kind and any other foreign
objects.
9. Always keep the Trimmer Line Holder maintained
in good working condition.
99922205595
Pro-Line Head KIT 99944400000
WARNING
INSTALLATION
1. Inspect kit to verify all items were received.
2. Remove the front cover. Insert a 9/16" open end
wrench into trimmer body, rotating the mow ball
as necessary to engage the trimmer shaft. Turn
the trimmer head weldment counterclockwise to
remove.
3. Remove the existing trimmer head disk and insert
the Trimmer Line Holder onto the trimmer spindle.
4. Replace the trimmer head weldment and twist
clockwise to tighten. Remove wrench and replace
front cover before operation.
INSTALLING/REMOVING TRIMMER STRING
1. Slide one end of the trimmer string through the line
holder along one side of the raised tab (Figure 1).
2. Loop the string around the raised tab and slide
through the other side of the line holder.
3. Make sure the string ends are even and pull to
ensure the string is snug behind the raised tab.
4. To remove the string, use a screwdriver (or similar
object) to loosen the string from behind the raised
tab. Pull to remove the string from the line holder.
- 1 -
INSTRUCTION SHEET
@2020 ECHO Incorporated. All Rights Reserved.