Hedge And Shrub Trimming Operation; Basic Hedge Trimming Operation - Echo HC-331ES Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Basic hedge trimming operation

NOTE
This product is designed to cut shrubs and hedges with branches no larger than 6 mm in diameter.
When starting to trim, run the engine at full throttle. Cutting at less at than full speed can damage the clutch by allowing it to
slip. When you do not conduct trimming or cutting work, do not run the engine at full throttle.
1. Throttle trigger
All manuals and user guides at all-guides.com

Hedge and shrub trimming operation

Hedge and shrub trimming operation
2. High speed
3. Idling
17
Pulling the throttle trigger after the engine is started will cause
the engine speed to rise and the cutter blade to start moving.
Adjust the engine speed depending on, for example, the
amount of the hedges to be cut.
Conduct cutting work with the cutter blade positioned away
from you. Do not orient the cutter blade toward yourself or put
it closer to yourself.
When cutting the top of the hedges or shrubs, do so by moving
the cutter blade from side to side. Tidy trimming will be made
possible by moving the blade slightly cast down.
When cutting sides, do so by moving the cutter blade in the
bottom-up direction for tidy trimming.
Do not press the cutter blade against the objects like trees.
Operate the product in accordance with the movement and the
speed of the cutter blade.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hc-341es

Tabla de contenido