Other Problems - Omcan IC-CN-0012 Manual De Instrucciones

Troubleshooting
The ice cubes have
shape deformities
Cubes are partially
formed—are white at the
bottom

OTHER PROBLEMS

Problem
The body is electrified
Scales occur frequently
inside the machine
Loud noise during
operation
Water is leaking out of the
unit
Filter
Water trough
The room temperature
Water trough
Check part or point
Ground line
Lines
Electric component
The water quality
Spring of the internal
compressor
Water pump
Pipeline system
Feet
Fan motor
The operation
Water supply connection
Drainage tray on top of
the compressor
Water filtration element
needs to be changed.
Water trough level is too
low.
The room temperature
is out the stated range,
the water pump stops
automatically.
Water trough level is too
low.
Possible Cause
The ground line isn't in
the socket.
The lines are not
insulated.
The electric component is
not insulated.
The rigidity of the water
quality is too high.
The spring of the internal
compressor drops.
The noise of the water
pump
Pipeline system resonate
The feet are not leveled
The fan motor is loose,
the clearance of the rotor
is bigger, the fan blade
turns back
Some water drops to the
floor when you open the
door to take out ice from
ice storage bin.
Water supply connection
is leaking.
Water full probe is out of
function
18
Replace the filter.
Adjust the water floater.
Make the temperature
return within the stated
range.
Adjust the water floater.
Probable Correction
Please use the socket
meeting the standard.
Adjust, reconnect /
replace lines
Replace this electric
component.
Use a water-soften
apparatus installed in
front of the water inlet.
Replace the compressor.
Replace the water pump.
Clear pipeline system
Level and lock the feet.
Relocate the fan motor /
replace
Normal condensation on
the door or some water
from the ice. Take care
when you take out ice.
Tighten the fitting.
Replace with a new one.