Black and Decker KC360LN Manual De Instrucciones página 8

ENGLISH
Warning! Do not use the tool while it is connected to the charger.
Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C.
Selecting the direction of rotation (fig. C)
For tightening screws, use forward (clockwise) rotation. For loosening screws use reverse
(counterclockwise) rotation.
To select forward rotation, push the forward/reverse slider (2) to the forward position.

To select reverse rotation, push the forward/reverse slider (2) to the rearward position.

To lock the tool, set the forward/reverse slider into the centre position.

Screwdriving (fig. C)
Select forward or reverse rotation using the forward/reverse slider (2).

To switch the tool on, press the on/off switch (1).

To switch the tool off, release the on/off switch (1).

Spindle lock
This tool is fitted with an automatic spindle lock so that it can be used as a normal
screwdriver. Use the tool this way to loosen very tight screws or to firmly tighten screws.
Hints for optimum use
Always use the correct type and size of screwdriver bit.

If screws are difficult to tighten, try applying a small amount of washing liquid or soap as

a lubricant.
Use the spindle lock to loosen very tight screws or to firmly tighten screws.

Always hold the tool and screwdriver bit in a straight line with the screw.

When screwing in wood, it is recommended to drill a pilot hole with a depth equal to the

length of the screw. A pilot hole guides the screw and prevents splintering or distortion of
the wood. For the optimum size of the pilot hole, refer to the table below.
When screwing in hardwood, also drill a clearance hole with a depth equal to half the

length of the screw. For the optimum size of the clearance hole, refer to the table below.
Screw size
No. 6 (3.5 mm)
No. 8 (4 mm)
No. 10 (5 mm)
8
Pilot hole ø (softwood)
2.0 mm
2.5 mm
3.0 mm
Pilot hole ø (hardwood)
2.5 mm
3.0 mm
3.5 mm
Clearance hole
3.6 mm
4.5 mm
5.0 mm