ECRON RD40 AC Manual De Usuario página 36

Control panel and remote control
A. On LED
B. Swing LED
C. Speed LEDs
(high-medium-low)
D. OFF button
E. TIMER button
F. ON/SPEED button
G. Swing button
H. Timer LED (0.5-1-2-4 hours)
1. Plug the fan into an appropriate
power supply. The LED (A) will
light up.
2. Switch on the fan by pressing
the ON/SPEED button (F) on the
control panel. The fan will start to
operate at low speed. The low
speed LED (C) will light up.
3. To change the speed, press the
button (F) several times. The
speed will change with every press
36
and the corresponding LED will
light up.
4. To activate swing, press the
SWING button (G). The swing LED
(B) will light up and the fan will
start to swing horizontally. To stop
the swing, press the button
(G) again.
5. The fan has a timer. After
switching on the fan, press the
TIMER button (E) and the fan will
start to operate for the time
selected: press the TIMER button
several times. The time changes
with each press and the
corresponding LEDs (H) will light
up. When the programmed time
has elapsed, the fan will switch off
automatically. The timer can be
programmed from 0.5 to 7.5
hours. In this setting, all of the
time LEDs are lit up.
6. The air flow can be adjusted by
moving the fan upwards or
downwards. Loosen the neck
screw (9) and adjust the motor to
the desired vertical position.
Tighten the screw again to fix it
in position.