Instructions For Fitting The Blades And Grilles - ECRON RD40 AC Manual De Usuario

BASE MOUNTING
INSTRUCTIONS
1. Loosen and remove the 4
screws located in the base bars.
Cross bar A and bar B so that they
are interlaced, forming a
cross shape.
2. Ensure that the 4 slots in the
bars remain aligned with those of
the base plate of the outer tube.
Fit the plate to the bars and
tighten the 4 screws.
3. Loosen and remove the height
adjustment ring through the
upper part of the inner tube. Move
the base decorative cover through
the tube to the base.
4. Refit the height adjustment
ring in the upper part of the inner
tube. Pull the inner tube through
the outer tube to adjust it to the
desired height and tighten the
adjustment ring to fix it
in position.
5. If necessary, loosen the screw
gently and adjust it by turning it
anti-clockwise. Move the switch
box in the inner tube and tighten
34
the adjustment screw, ensuring
that it is correctly adjusted.
INSTRUCTIONS FOR
FITTING THE BLADES
AND GRILLES
1. Loosen the plastic washer from
the front part of the motor body,
turning it anti-clockwise.
2. Position the rear grille against
the front part of the motor body
with the handle on top, ensuring
that the positions of the pins in
the housing fit correctly into the
slots in the rear grille.
3. Tighten the washer by turning
it clockwise. DO NOT
TIGHTEN EXCESSIVELY.
4. Move the blades through the
motor shaft, placing the groove on
the rear part of the blades into the
pin that passes through the
motor shaft.
5. Tighten the fastening nut by
turning it anti-clockwise.
6. Place the front grille against
the rear grille so that the holes in
the edges match. Fit the screw