Tivoli Audio SongBook Manual Del Propietário página 8

English
"PM" will appear for afternoon/evening hours but there is no "AM" designation for morning
hours. Now press the Time Set button to adjust the minutes using the Tune Up/Down buttons.
(Figure 7) The minutes will not affect the hour setting. Press the Time Set button again to
save the settings.
NOTE: Non-US models use a 24 hour alarm format.
Figure 5
B. To set the Alarm to wake: Set the SongBook to the FM or AM station you wish to wake to
and that will be broadcasting during the time you wish to wake (or set to Off or Aux to wake to
an increasing beep) and adjust the volume level accordingly. Press and hold the Alarm button.
A beep tone will be heard confirming the Alarm is set to wake and the word "Alarm" will show
on the display. The SongBook will go into Standby mode and the display will show "Standby".
(Figure 8) If the Alarm has been set and the SongBook is in the Off position, the alarm wake
time will show in the upper right hand corner. When the alarm activates, the LCD will light
up and the word "Alarm" will flash. (Figure 9) Should you opt to wake to the beep, the beep
will sound for 60 seconds, then pause for 60 seconds, then resume for another 60 seconds.
This pattern will repeat for up to one hour or until the Alarm button is pressed.
If the alarm is set and activates but the batteries are too weak to play the radio, the beep will
sound instead, provided there is enough battery power remaining. The LCD will show an "E"
to indicate the batteries are empty.
Figure 8
C. To Cancel the Alarm: When the alarm activates, press the Alarm button to cancel the
alarm and the word "Alarm" will disappear from the display, the display will flash the word
"Off"(Figure 10) for several seconds, and the unit will go into Standby. Changing the source
knob to another position will cancel Standby mode. Once the alarm activates, if it is not
manually turned off, the Alarm will shut off automatically after approximately 60 minutes to
preserve the batteries and the display will say "Standby".
Figure 10
8
Figure 6
Figure 9
Figure 7