Kathrein UFO 382 Manual Del Usuario página 11

2.6 Selection of output channel or output frequency
A 1236 MHz
TV Das Erste
Outp. Ch12
stereo Vol-3
*** UFO 382
224,25 MHz Norm
16:9 PanS.
< Return:
2.7 Selection of output level
*** UFO 382
224,25 MHz Norm
16:9 PanS.
< Return:
2.7.1 Sound mode-switching
A 1236 MHz
TV Das Erste
Outp. Ch12
stereo Vol-3
Note :
The operating mode "dual sound" can only be used if language 1 and language 2 of the processed programme are
transmitted with the same PID within an MPEG audio data stream. This is the case in programmes in which the left
sound is replaced by language 1 and the right sound replaced by language 2.
Dual-sound processing of two different MPEG audio data streams (two different PIDs) is not possible !
27,500 MS/s
deu
224.25 MHz
AV
***
B/G
Level –10
Submenu >
***
B/G
Level -10
Submenu >
27,500 MS/s
deu
224.25 MHz
AV
After having selected the output channel field, use the "+" and
"–" keys on the control unit to set the desired output channel.
Displayed is always the corresponding video carrier frequency.
The output channels in a frequency range between 110 and
862 MHz (S2-K69) can be set in the channel grid 7 MHz or 8 MHz,
depending on the set TV standard.
After pressing the submenu key, the submenu will appear showing
the following settings/displays :
– Video carrier, which can be fine adjusted in 250 kHz steps
– TV standard. The following can be set: B/G, D/K and I
– Procedure during reception of wide picture format 16:9
– Letterbox
– Pan & Scan (always 4:3)
After having chosen the field for the output level, use the "+" and
"–" keys on the control unit to set the desired output level.
The output level can be set continually in 40 steps.
Setting limits are marked with "min" and "max" (comparable to
right and left stops of a conventional variable attenuator).
Effect switchover with the "+" or "–" keys.
Selection between sound modes "stereo", "mono",
"dual sound" and "auto".
"Auto" effects sound control via the Sat signal.
5