Troubleshooting - AIRIS Praxis N1204 Manual Del Usuario

Troubleshooting

Problem
The Wireless LAN/
Bluetooth/3.75G/HSPA
modules cannot be detected.
The Bluetooth module is off
after resuming from Sleep.
A file cannot be copied to/from
a connected Bluetooth
device.
The captured video files from
the PC Camera are taking up
too much disk space.
20
All manuals and user guides at all-guides.com
The modules are off. Check the LED indicator
Bluetooth/3.75G/HSPA module is on or off (see
LED indicator is off, then press the Fn + F11 (WLAN), Fn + F12 (Bluetooth) or Fn +
HSPA) in order to enable the modules (see
The Bluetooth module's default state will be off after resuming from the Sleep power-saving state.
Use the key combination (Fn + F12) to power on the Bluetooth module after the computer resumes
from Sleep.
Transferring data between the computer and a Bluetooth enabled device is supported in one
direction only (simultaneous data transfer is not supported). If you are copying a file from your
computer to a Bluetooth enabled device, you will not be able to copy a file from the Bluetooth
enabled device to your computer until the file transfer process from the computer has been
completed.
Note that capturing high resolution video files requires a substantial amount of disk space for each
file.
Note that the Windows system requires a minimum of 15GB of free space on the C: drive system
partition. It is recommended that you save the capture video file to a location other than the C:drive,
limit the file size of the captured video or reduce video resolution (Options > Video Capture Pin... >
Output Size).
Possible Cause - Solution
and/or function key indicator to see if the WLAN/
Table 2 on page 8
Table 5 on page 10).
and Table 5 on page 10). If the
(3.75G/