Starting + Stopping; Operating Tips - sunjoe SWD6600 Manual Del Operador

5. Select desired accessory, connect it with the end of the
extension tube, press firmly to lock securely. Your wet/
dry vacuum is ready for use. If no extension is needed,
connect the desired accessory directly to the attachment
handle (Fig. 4).
Fig. 4
Extension
tube
Accessories
Operation
m
WARNING!
This equipment incorporates parts such
as switches, motors or the like that tend to produce arcs or
sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive
liquids or vapors, as electrical devices produce arcs or sparks
which can cause a fire or explosion – do not use at filling
stations or anywhere gasoline is stored or dispensed.

Starting + Stopping

Do not switch on the wet/dry vacuum until it has been
completely assembled. Before switching on the unit, always
check the power cord for signs of damage. Use only intact
cords.
m
WARNING!
Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
m
WARNING!
Before switching on the wet/dry vacuum,
make sure that it is not in contact with any foreign objects.
1. Make sure the filters are installed before starting.
2. Make sure the power head and the suction hose are
installed properly and locked securely.
3. Install the desired brush attachment onto the end of the
hose. Use the extension tubes if needed.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
Plug the power cord into the outlet (Fig. 5). If an extension
cord is used, make a knot with the two cords as shown in
Table 1.
Fig. 5
Attachment
handle
5. To start the unit, turn the ON/OFF switch to the ON
position (Fig. 6), as indicated.
Fig. 6
ON/OFF
switch
6. To stop the unit, turn the ON/OFF switch to the OFF
position (Fig. 6), as indicated.
7. To adjust the strength of the airflow, move the sliding block
on the attachment handle (Fig. 7).
Fig. 7

Operating Tips

This electric wet/dry vacuum is designed to clean hard
surfaces. It is only suitable for vacuuming wet or dry, light
materials. The vacuuming of heavy materials such as metal,
stones, branches, broken glass is expressly excluded.
m
WARNING!
good artificial light.
• Make sure the power head is properly installed and
secured when using. Make sure each lock is secured.
Failure to properly secure the locks could cause the power
head to release from the tank.
• Double check to make sure the filters are not broken or
torn. Do not use filters that are broken or torn. Handle the
filters carefully when removing and installing.
8
Power cord
Attachment handle
Sliding
block
Use the wet/dry vacuum only in daylight or