Carton Contents - sunjoe SWD6600 Manual Del Operador

Unpacking

Carton Contents

• Electric wet/dry vacuum
• Caster wheels (2)
• Large wheels (2)
• Screws (4)
• Suction hose
• Extension tubes (2)
• Wet + dry floor brush
• Carpet + floor brush
• Dust brush
• All-purpose nozzle
• Crevice nozzle
• Manual + Registration card
1. Carefully remove the electric wet/dry vacuum and check
to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the wet/dry vacuum.
The packaging is made of recyclable materials. Properly
dispose of these materials in accordance with local
regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suffocation
risk!
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal injury.
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position before attaching or removing the
suction hose.
customer service center at
®
1. Turn the dust tank upside down, and insert the 2 Caster
wheels into the holes at the bottom of base. Press wheels
down firmly to secure (Fig. 1).
2. Install the 2 Large wheels '1' and '2' into the correct
positions as shown. Fix them into place with 2 screws
each (Fig. 1).
Fig. 1
Screws
Large wheels
3. Depress the locking button on the air inlet while inserting
the hose connector. Push firmly to secure (Fig. 2).
Fig. 2
Air
inlet
Locking
button
Hose connector
4. Two extension tubes are included with the unit. If needed,
take the slightly narrowed end of the first extension tube
and using a twisting motion, insert into the attachment
handle. Press firmly to secure. In the same manner,
assemble the second tube (Fig. 3).
Fig. 3
Extension tube
7
Caster
wheels
Attachment
handle