Cleaning The Dust Tank - sunjoe SWD6600 Manual Del Operador

Cleaning the Filters
m
WARNING!
The foam filter must be cleaned every time
after wet vacuuming.
1. Switch off and unplug the unit. Take the unit outside to
clean it to avoid creating a mess indoors.
2. Remove the power head from the collection tank.
3. Remove all the inner housing components
as shown (Fig. 9).
Fig. 9
4. Separate the dust tube from the inlet filter by rotating
clockwise to unlock. Then remove the ring foam filter
using the hook-and-loop fastener (Fig. 10).
Fig. 10
Inlet filter
Ring foam filter
Hook-and-loop
Dust
fastener
tube
5. Use a mild soap and water solution to wash all the
housing components and rinse with clean water. Allow the
filters and housing to air dry for 24 hours before
re-installing.

Cleaning The Dust Tank

Clean the equipment routinely after each use:
1. Before all the inner housing components are re-installed,
empty the dust tank (Fig. 11).
Nylon mesh
Foam filter
Multiple
filtration
Inlet filter
Ring foam filter
Dust tube
10
Fig. 11
2. To empty a heavy tank of liquid, simply unscrew the drain
knob and allow the liquid to flow out (Fig. 12).
Fig. 12
3. Clean the tank with water and allow it to dry completely.
4. To re-assemble the inner housing components, lock the
dust tube by rotating counter-clockwise. Re-attach the
ring foam filter and place all the components back into the
dust tank in the order shown (Fig. 13).
Fig. 13
Nylon mesh
Foam filter
Multiple
filtration
Inlet filter
Ring foam filter
Dust tube