Tools And Materials; Before You Begin - Kohler K-8359 Guia De Instalacion

Tools and Materials

Drill with 1-1/4"
& 7/8" Hole Bits
Level
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Please read all instructions before you begin.
Observe all local plumbing and building codes.
The dimensions given assume the spout and bath are mounted on
the same surface. Adjust the dimensions according it the spout
and bath are mounted on different surfaces.
If this product is used with an overflowing bath, the 2 x 4
construction should tuck under the outer rim of the bath.
Installer supplied copper tubing must be 5/8" O.D. (1/2" Nom.).
The plaster guard diameter is 7/8" from the spout.
Leave the protective sleeve on the spout supply tube until spout
installation. This is an O-ring sealing surface which may be
damaged when unprotected.
The finished wall to which the spout is installed should add less
than 1-1/2" (3.8 cm) of thickness to the outside of the rough-in
wall.
1006092-2-B
Tape
Measure
Plumbers
Masking
Putty
Tape
2
Pencil
Kohler Co.