Kuppersbusch IKE 240-2 Istrucciones Para El Montaje Y El Uso página 17

Apply the sealing strip pushing it between the
refrigerator and the adjacent cabinet.
From the plastic cover (E), which is used to cover the
hinge with the pivot pin, you must take away the part as
indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that facilates
the removal of this coomponent.
"Remove the part marked with DX, if the pivot pin is
inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into hinge
holes.
Snap vent grille (B) and hinge covers (E) into
position.
Separate parts Ha, Hb,Hc, Hd as shown in the figure
Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
D724
C
D
E
E
Ha
Hb
Hc
Hd
PR266
ca. 50 mm
90°
90°
ca. 50 mm
B
17