RISCO Group LuNAR DT AM Grade 3 Guia De Instalacion página 22

EOL RESISTORS
JUMPERS
The jumpers are used when connecting the detector to
a DEOL or TEOL Zone. The jumpers allow the selection
of TAMPER, ALARM E.O.L resistors (1K, 2.2K, 4.7K, 5.6K
or 6.8K), according to the control panel settings. An
additional double jumper allows the connection of 12K
FAULT/AM E.O.L resistor (see EOL Resistors Schematic).
Follow the terminal block connection diagram when
connecting the detector to a Double/Triple
End Of Line (DEOL/TEOL) Zone
Ind. LuNAR RK200DTG3 Installation Guide 21