Parts And Maintenance - Ingersoll Rand 7RALC1 Especificaciones Del Producto

4. Insert the Clutch Adjusting Key into the hole in the Clutch Adjusting Nut and, while holding
the Nut against rotation, rotate the Bit Holder counterclockwise until there is no compression
on the Clutch Spring.

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
80167299_ed2
EN
EN-3