Pioneer RSM400DV Manual De Instrucciones página 20

Troubleshooting
Symptom
POWER
No power
RADIO
No sound
Some noise occurs.
DVD/CD
The unit does not start
playback
No picture
REMOTE CONTROL
The remote control does
not work properly.
TAPE
Unable to record
20
All manuals and user guides at all-guides.com
Cause
The power cord is not plugged in.
The function switch is not set to the Radio mode.
There are electronic devices near the unit.
The antenna is positioned or connected poorly
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The TV is not set to receive the video signal
The remote control is not pointed at the remote sensor of
the unit directly.
The battery in the remote control is exhausted.
Record protect tabs are removed.
Correction
Plug in the power cord.
Set the switch to the Radio mode.
Set the unit far from the devices.
Check the antenna connection and adjust its position
Insert a playable disc.
Place the disc with the playback side down.
Place the disc on the disc tray correctly inside the guide.
Clean the disc.
Select the appropriate video input model on the TV so the
picture from the unit appears on the TV
Point the remote control to remote sensor directly of the
unit.
Replace the battery with new ones.
Cover holes on back edge of tape with tap.