Black and Decker CS3653LC Manual De Instrucciones página 7

Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C
u
and 40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions
u
p
given in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
(Original instructions)
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off trigger switch
2. Forward/reverse slider
3. Bit holder
4. Handle adjustment button
5. Handle
6. Micro USB charging connector
7. LED work light
8. State of charge indicator
9. Magnetic bit storage
Assembly
Fitting and removing a screwdriver bit or socket
(fig. A)
Warning! Make certain the tool is locked to prevent switch
actuation before installing or removing accessories.
To fit a screwdriver bit (9), push it into the bit holder (3)
u
until it locates.
To remove a screwdriver bit, pull it straight from the bit
u
holder.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Charging the battery (fig. B)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before. The battery may become warm
while charging; this is normal and does not indicate a
problem.
Warning! Only use the charger provided to charge the
tool - CS3653LC.
To charge the battery, insert the charger plug (10) into
u
the connector (6).
Plug in the charger.
u
ENGLISH
7