Black and Decker CS3653LC Manual De Instrucciones página 7

Warning! Never attempt to replace the charger unit with
u
a regular mains plug.
Features
1. On/off trigger switch
2. Forward/reverse slider
3. Bit holder
4. Handle adjustment button
5. Handle
6. Micro USB charging connector
7. LED work light
8. State of charge indicator
9. Magnetic bit storage (bit not included)
Assembly
Fitting and removing a screwdriver bit or socket
(fig. A)
Warning! Make certain the tool is locked to prevent switch
actuation before installing or removing accessories.
To fit a screwdriver bit (9), push it into the bit holder (3)
u
until it locates.
To remove a screwdriver bit, pull it straight from the bit
u
holder.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (fig. B)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Only use the charger provided to charge the tool -
CS3653LC.
To charge the battery, insert the charger plug (10) into the
u
connector (6).
Plug in the charger.
u
The state of charge indicator (fig. B) will display the
u
current level of charge in the tool.
Leave the tool connected to the charger for 3 hours.
u
The charger may hum and become warm while charging; this
is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
State of charge indicator (fig. B)
The tool is fitted with a state of charge indicator. This can be
used to display the current level of charge in the battery during
use and during charging.
(Original instructions)
During charging
During charging the state of charge indicator will automaticaly
u
show the current level of charge.
During use
Note: Do not check state of charge while screwdriver is in
use or under load. This will result in an inacurate reading. To
receive an accurate reading, check the state of charge with
the tool under no load.
Set the tool to the forward position. The state of charge
u
indicator will not function with the tool set in reverse or in
the lock off position.
Press the trigger switch (1). The LED's in the state of
u
charge indicator (8) will light up depending on the level of
charge remaining.
Number of LED's
Three
Two
One
Zero
Adjusting the handle (fig. C & D)
For optimum versatility, the handle can be set to two different
positions.
Press the handle adjustment button (4).
u
Twist the handle into the desired position.
u
Release the button.
u
Selecting the direction of rotation (fig. E)
For tightening screws and drilling pilot holes, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
To select forward rotation, push the forward/reverse slider
u
(2) to the left.
To select reverse rotation, push the forward/reverse slider
u
to the right.
To lock the tool, set the forward/reverse slider into the
u
centre position.
Selecting the direction of rotation (fig. F)
For tightening, use forward (clockwise) rotation. For loosening,
use reverse (counterclockwise) rotation.
To operate the tool, press and hold the trigger switch (1).
u
To switch the tool off, release the trigger switch (1).
u
LED work light
The LED work light (7) is activated automatically when the
trigger is depressed. The LED work light will illuminate when
the trigger is partially depressed, before the unit begins
running.
ENGLISH
Charge level
Battery full
Battery OK
Battery low
Battery Empty, charge immediately
7