Message Codes; Care; Warranty; Safety Instructions - DeWalt DW03101 Manual Del Usuario

EN

Message Codes

If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a
number, press the Clear button and
observe the following instructions:
No. Cause
156 Transverse tilt
greater than 10°
162 Calibration mistake Make sure, the device
204 Calculation error
252 Temperature too
high
253 Temperature too
low
255 Received signal too
weak, measuring
time too long
256 Received signal too
high
257 Too much back-
ground light
258 Measurement
outside of meas-
uring range
260 Laser beam inter-
rupted
18

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents
or solvents.

Warranty

Correction
Europe:
Hold the instrument
• 30 day no risk satisfaction guarantee
without any transverse
• One year free service
tilt.
• One year full warranty
Detailed information are available on the
is placed on a abso-
internet at www.2helpU.com.
lutely horizontal and flat
surface. Repeat the
North America:
calibration procedure. If
the mistake still occurs,
• Three year limited warranty
contact your dealer.
• One year free service
Perform measurement
• 90 day money back guarantee
again.
Detailed information are available on the
Let device cool down.
internet at www.dewalt.com.
Warm device up.
Change target surface
(e.g. white paper).
Change target surface
(e.g. white paper).
Shadow target area.
Correct range.
Repeat measurement.
Dewalt DW03101

Safety Instructions

The person responsible for the instrument
must ensure that all users understand
these directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Europe:
DEWALT
D-65510 Idstein, Germany
www.2helpU.com
www.dewalt.eu
North America:
DEWALT Industrial Tool Co.
Baltimore, MD21286, USA
For service call 1-800-4-DEWALT.
www.dewalt.com
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regula-
tions relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.