Technical Data
Distance measurement
Typical Measuring Tolerance* ± 1.0 mm / 0.04 in ***
Maximum Measuring Toler-
± 2.0 mm / 0.08 in ***
ance**
Range of target plate
100 m / 330 ft
Typical Range*
80 m / 262 ft
Range at unfavourable condi-
60 m / 197 ft
tion ****
Smallest unit displayed
0.1 mm / 1/32 in
Ø laser point
6 /30 / 60 mm
at distances
(10 / 50 / 100 m)
Tilt measurement
Measuring tolerance to laser
± 0.2°
beam*****
Measuring tolerance to
± 0.2°
housing*****
Range
360°
General
Laser class
2
Laser type
635 nm, < 1 mW
Beam divergence
0.16 x 0.6 mrad
Impulse duration
0.2 x 10
Protection class
IP54 (dust- and splash
water protected)
Autom. laser switch off
after 90 s
Autom. power switch-off
after 180 s
Battery durability (2 x AAA)
up to 5000 measure-
ments
Dimension (H x D x W)
125.2 x 58 x 32.6 mm
4.9 x 2.3 x 1.3 in
Weight (with batteries)
154 g / 5.43 oz
Temperature range:
- Storage
-25 to 70 °C
-13 to 158 °F
- Operation
-10 to 50 °C
14 to 122 °F
* applies for 100 % target reflectivity (white painted
wall), low background illumination, 25 ºC
** applies for 10 to 500 % target reflectivity, high back-
ground illumination, - 10 ºC to + 50 ºC
*** Tolerances apply from 0.05 m to 10 m with a confi-
dence level of 95%. The maximum tolerance may
deteriorate to 0.1 mm/m between 10 m to 30 m and to
0.2 mm/m for distances above 30 m
**** applies for 100 % target reflectivity, background
illumination of approximately 30'000 lux
***** after user calibration. Additional angle related
deviation of +/- 0.01° per degree up to +/-45° in each
quadrant. Applies at room temperature. For the whole
operating temperature range the maximum deviation
increases by +/- 0.1°.
For accurate indirect results, the use
of a tripod is recommended. For
accurate tilt measurements a trans-
verse tilt should be avoided.
-9
-9
s - 0.8 x 10
s
Dewalt DW03101
Functions
Distance measuring
yes
Min/Max measuring
yes
Permanent measuring
yes
Stake-out
yes
Addition/Subtraction
yes
Area
yes
Volume
yes
Pythagoras
2-point, 3-point,
partial height
Smart Horizontal Mode /
yes
Indirect height
Height tracking
yes
Levelling
yes
Memory
20 displays
Beep
yes
Illuminated display
yes
Multifunctional endpiece
yes
EN
17