Heylo HL 800 Manual De Instrucciones página 18

When the machine is switched on, you can press the "Timer" button to let the
machine run automatically for a certain period of time. You can select the time
period from 30 minutes to 12 hours. You press the button until the desired time
appears on the display. 5 seconds after the last press, the unit switches back to the
air quality display. (PM2.5 value). To switch off the timer function again, press the
button until none of the hour signals below the display are lit up.
Press the "Child Lock" button to activate the child lock. Press and hold the child lock
button for 5 seconds to cancel the function.
The filter indicator lights up red after 3000 hours of operation.
You should then replace the main filters.
You can reset the display by pressing the button for 3 seconds.
Then the filter timer starts again from the beginning.
WIFI function
To turn on the WIFI function, press and hold the mode button for 5 seconds (without
turning on the device).
The WiFi pattern changes to flash status. Now set the mobile phone in pairing mode.
APP and machine are paired. For more information, refer to the WLAN instructions
of the mobile phone.
After the pairing is successful, the WiFi pattern is displayed.
If the machine is in an environment where there is no wireless LAN, the WIFI icon
will not light. After turning on the device, the WiFi icon flashes slowly. Only when
the WiFi signal is received, the indicator lights up continuously.
The unit can now be operated via the mobile phone in standby and operating mode.
Air quality indicator display
PM2.5 Value
smaller 100
101-200
201-300
➢ 300
Light sensor:
In automatic mode, the product is put into sleep mode when the
ambient light falls below the value <5×. It exits the sleep mode
again, after the ambient light exceeds <5× for 3 minutes and then returns automatic
mode
This product is supplied with a remote control powered by 3V lithium dry cells.
(Please remove the dry cells if you do not use the remote control for a long period of
time). The controls on the user interface on the unit and on the remote control are
directly similar: all functions and operating modes are basically identical.
Air quality Display colour
Very good Green
Good
Poor Orange
Very poor
18
Blue
Red
EN