Select Cycle - Sears Kenmore 110.4443 Manual De Uso Y Cuidado

For Portable Installations
Open the faucets connected to the water supply hoses.
Wash and Rinse water temperatures are set at your faucet.
The Temperature control does not set the temperature.
Adjust the Hot and Cold water faucets to desired wash
temperature. Keep the temperature control set at Cold.
NOTE: The Cold setting allows water from the faucet to
enter the washer, but does not control the incoming water
temperature.
For a rinse temperature that is different from the wash
temperature, you must adjust the water temperature at
the faucet after the washer has completed its initial fill.
To test the water temperature, press the red water-flow button
on the hose connector. Water will be released when the button
is pressed, allowing you to sample the temperature.
For Permanent Installations
The Rinse and Spin cycles default to a cold rinse, all other
cycles default to a warm rinse. Press the Wash Temp button
to choose a different wash temperature.
Selecting Water Temperatures
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items.
Wash Temp
Hot
Some cold water is added
to save energy. This will be
cooler than your hot water
heater setting.
Warm
Some cold water will be
added, so this will be cooler
than what your previous
washer provided.
Cool Lights
Some warm water may
be added to assist in
soil removal and to help
dissolve detergents.
Cool Darks
A small amount of warm
water may be added to
assist in soil removal and
to help dissolve detergents.
Water will be colder than
"Cool Lights" setting.
Cold
This is the temperature from
your faucet.
NOTE: In wash water temperatures colder than 60ºF (15.6ºC),
detergents do not dissolve well. Soils can be difficult to remove.
Some fabrics can retain wear wrinkles and have increased
pilling (the formation of small lint-like balls on the surface
of garments).
18
Suggested Fabrics
Whites and pastels
Durable items
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
Dark colors that bleed or fade
Light soils
9.

Select cycle

Press the Cycle Select button to select your wash cycle.
See "Cycle Guide" for details on cycle features.
10.
Press START/PAUSE to begin wash cycle
Press START/PAUSE to start the wash cycle. When the
cycle has finished, the end-of-cycle signal will sound (if set).
Promptly remove items when cycle is done to avoid odor, re-
duce wrinkling, and avoid rusting of metal hooks, zippers, and
snaps.
Unlocking the lid to add items
If you need to open the lid to add 1 or 2 missed items:
Press START/PAUSE to pause washer; the lid will unlock once the
washer movement has stopped. This may take several minutes if
the load was spinning at a high speed. Then close lid and press
START/PAUSE again to restart the cycle.
To stop or restart your washer:
To stop the washer at any time, press START/PAUSE and the
■
cycle will pause.
To restart the washer, press START/PAUSE and the cycle will
■
resume.