Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Stacked
3"
(76 mm)
12"
(305 mm)
1"
(25 mm)
Recessed area
Electrical Requirements
A 120 V, 60 Hz., AC only, 15 or 20 A, fused electrical
■
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
This washer is equipped with a power supply cord having
■
a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
■
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating
outlet is not available, it is the personal responsibility and
obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
If codes permit and a separate ground wire is used, it is
■
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
■
6
3"
(76 mm)
12"
(305 mm)
DRYER
48 in.
2
(310 cm
WASHER
1"
24 in.
2
(25 mm)
(155 cm
1"
(25 mm)
3"
(76 mm)
Closet door with vents
Check with a qualified electrician if you are not sure the
■
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
■
2
)
2
)
Remove Shipping Material
Before you install your washer, remove all shipping material.
To avoid damaging floor, use a large flat piece of cardboard
from the washer carton. Place cardboard under entire back
of the washer.
Firmly grasp the body of the washer and gently lay it on the
corner posts.
Remove plastic foam packaging from underneath the washer.
Stand the washer up.
Remove tape from washer lid. Open washer lid and remove
foam shipping piece, parts bag, and hoses from washer basket.
Close the lid.
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
