Troubleshooting - Sears Kenmore 110.4443 Manual De Uso Y Cuidado

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Vibration or Off-Balance
Vibration, rocking, or
"walking"
Vibration during spinning
or washer stopped
Noises
Clicking or metallic noises Objects may be caught in washer
Gurgling or humming
Humming
Whirring
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Not enough water
in washer

TROUBLESHOOTING

Possible Causes
Feet may not be in contact with
the floor and locked.
Washer may not be level.
Load could be unbalanced.
drain system.
Washer may be draining water.
Load sensing may be occurring.
Basket may be slowing down.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as recommended. An unbalanced load can cause basket to be out of alignment
Load not completely covered in water. This is normal operation for an HE low-water washer. The load
Front and rear feet or wheels must be in firm contact with floor
and washer must be level to operate properly.
Check floor for flexing or sagging. If flooring is uneven, a ¾"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in the Installation Instructions.
Load items in loose heaps evenly around the washplate. Adding
wet items to washer or adding more water to basket could
unbalance washer.
Avoid washing single items. Balance a single item such as a rug or
jeans jacket with a few extra items. Redistribute the load, close
the lid, and press START/PAUSE.
Item or load not suitable for selected cycle. See "Cycle Guide"
and "Using Your Washer."
Empty pockets before washing. Loose items such as coins could fall
between basket and tub or may block pump. It may be necessary
to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during the spin/drain cycles.
You may hear the hum of the sensing spins after you have started
the washer. This is normal.
You may hear the whirring sound of the basket slowing down.
This is normal.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure fill hose flat washers are properly seated.
Properly secure drain hose to drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets).
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
will not be completely underwater. The washer senses load sizes
and adds correct amount of water for optimal cleaning.
IMPORTANT: Do not add more water to washer. Adding water lifts
the items off the washplate, resulting in less effective cleaning.
Run Clean Washer cycle to optimize the water level and
wash performance.
Solution
21