What's In The Box; Dipswitches - Risco RW132XWR Instrucciones De Instalación

1. Introduction
The 2-way wireless repeater increases the range between RISCO's 2-Way wireless
devices registered to the control panels, Agility and WiComm Pro. The repeater
receives messages from wireless devices that were assigned to it and resends these
messages to a control panel. A repeater can be registered to the control panel with
32 zones (including up to 8 PIR CAMs), 3 sirens, 3 keypads, 16 keyfobs and one I/O
expander. Up to 4 repeaters can be included per control panel.

What's in the Box

• 2-Way Wireless Repeater
• Power supply
• Installation Instructions
:
NOTE Keyfobs can operate with all repeaters including panels and
consequently should not be assigned to a specific repeater.

2. Dipswitches

Configuring the DIP Switch
DIP SW Description
1 Battery Status LED
ON:* Battery status LED is enabled
OFF: Battery status LED is disabled
Top Tamper Bypass:
2
ON: Front cover tamper bypassed
OFF:* Front cover tamper activated
Back Tamper Bypass:
3
ON: Back tamper bypassed
OFF:* Back tamper activated
Red LED ON: Battery charging
Red LED OFF: Discharging state or charging problem
Table 1
3