Testing The System - Risco RW132XWR Instrucciones De Instalación

Adding a Device to the Repeater
1. Select a device (such as, zone, siren, keypad or I/O expander) to assign the
repeater to.
Note: Keyfobs are automatically added to a repeater and there is consequently no
need to manually add a keyfob to a repeater.
2. For example, to add a detector to a repeater:
From the panel's Installer Menu, go to Programming > Radio Devices >
Modification > Zones > Parameter / Select Zone > Advanced Controls >
8) Change Assign
3. Select Via Repeater.
4. Click <OK>.
5. Repeat steps 1 to 4 to learn additional detectors for a maximum of 32
detectors per repeater.
NOTE:
When exiting Installer Mode, the panel sends the updated list to the repeater.
Removing a Repeater from a Panel
1. From the panel's Installer Menu, go to Programming > Radio Devices >
Delete > Repeater.
2. Delete the repeater without deleting devices enrolled to the repeater (1. Keep
Devices) or delete the repeater and move the devices to the panel (2. Devices
→ Main).
3. Click <OK>.
NOTES:
1. When replacing the Serial number of an enrolled repeater with the
Serial Number of a new repeater, all assigned devices will move to the new
repeater (as in option 1. Keep Devices).
2. When exiting Installer Mode, the panel sends the updated list to the repeater.

Testing the System

When the devices, repeater and control panel have been placed in their final
locations, test the complete system, as follows:
1. Calibrate the repeater (for instructions, refer to the control panel's
Installation Manual).
2. Perform a walk test and observe the LEDS of the devices and the repeater
(for instructions refer to the device's User Guide).
7