Kohler Prologue K-3593 Guia De Instalacion página 4

Measure height
of front rail.
2. Install the Drawer Slides
The drawer slides can be installed to the sink prior to the sink installation in cabinets with specific front rail
and drawer opening dimensions. If your cabinet has dimensions other than those listed in the table above,
the drawer slides will be installed later in the "Install the Drawer" section.
Measure the height of the front rail of the cabinet.
If the front rail height is not 11/16" (1.7 cm) or 1-1/2" (3.8 cm), proceed to the "Install the Sink"
section.
Determine Slide Placement
If the front rail height is 11/16" (1.7 cm) and the drawer opening height is 5" (12.7 cm), then loosely
secure the drawer slide to slot 1.
If the front rail height is 1-1/2" (3.8 cm) and the drawer opening height is 5" (12.7 cm), then loosely
secure the drawer slide to slot 2.
Install the Slides
NOTE: Slides may need to be extended to allow access to the slide mounting holes.
Attach the slides to the bracket using the screws. Position the screws through the appropriate slot.
Loosely secure the slides to the brackets with the washers and nuts.
Close the slide assemblies. You may need to pull the screws to allow the slide assembly to close.
Refer to illustration 5 in the "Install the Drawer" section.
1068810-2-A
Drawer
Slide
Slot 1
Front Rail
Height
11/16" (1.7 cm)
1-1/2" (3.8 cm)
Measure height of the drawer opening.
4
Slot 2
Bracket
Drawer
Opening Height
5" (12.7 cm)
5" (12.7 cm)
Slot
1
2
Kohler Co.