Device Description - Adler europe AD 7022 Manual De Uso

17. Do not use the vacuum cleaner to pick up flammable items (such as fuel, solvents).
18. Do not vacuum objects with sharp edges (e.g. broken glass).
19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.

DEVICE DESCRIPTION

1.1 Carrying handle
1.3 Motor housing
1.5 Clamp lock location
1.7 Air intake
1.9 Suction hose
1.11 Suction wands
2.1 Dust bag
3.1 Vacuum tank
USING THE VACUUM
Prior to starting vacuuming, do the following:
– Open the cover (1.3) by releasing the cover clamps (1.6).
– Remove all the accessories from the tank (1.8).
– Depending on the need, insert the dust bag (2.1) for dry vacuuming or the sponge filter (3.3) for sucking the water.
– Place the motor housing (1.3) on the vacuum tank (3.1).
– Snap the fastening clamps (1.6) in place (1.5) on the motor housing. After closing the clamps you will feel some slack – this is consistent
with the vacuum cleaner design. During the vacuum cleaner operation the motor housing will be firmly fixed to the tank. Any attempt to
close the clamp in a different position will result in breaking it and causing irreversible damage.
– Insert the wider end of the suction hose (1.10) into the air intake opening (1.7).
– Attach the suction wands (1.11) and brushes (1.12) to the other end of the hose.
– Turn the vacuum on with the on/off switch (1.2).
– If, when sucking the water, too much water collects in the tank, the float switch inside the guide will block the air intake to the vacuum
motor. If this is the case, stop vacuuming and empty the tank (3.1).
CLEANING AND MAINTENANCE
– Turn off the vacuum and unplug the power cord.
– Disconnect the suction hose and suction wand.
– Open the clamps and take off the motor housing.
– Wash the tank (3.1).
– Remove the sponge filter (3.3) from the float switch guide, shake and wash under running water.
– Empty the dust bag is it was used.
– Assemble the vacuum cleaner.
TECHNICAL DATA
Power supply: 220-240V~50Hz
Nominal power: 1000W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
1.2 On/off switch
1.4 Power cord rewind location
1.6 Fastening clamps
1.8 Vacuum tank
1.10 The wider end of the suction hose
1.12 Brushes
3.3 Sponge filter
DEUTSCH
4