Operating The Leaf Blower; Start The Motor - Grizzly Tools BLSB 3030 Traducción Del Manual De Instrucciones Original

GB
Open the filler cap carefully, so any
excess pressure that is present
can escape slowly.
Do not start the equipment near
the filling location.
Use suitable and authorised con-
tainers for storing the fuel.
There is a risk of fire or explosion
in case of non-observance.
Only use the fuel mix recommend-
ed in the instructions. This must
not be older than 3 months. In
case of non-observance, the motor
may be damaged and the guaran-
tee will be invalidated.
Avoid direct skin contact with pet-
rol and inhalation of petrol fumes.
They are hazardous to health!
The equipment is run with a
mix of unleaded petrol and
two-stroke engine oil (qual-
ity API TC) in the ratio 40:1.
Never use undiluted fuel. Use only
two-stroke engine oil (no four-
stroke engine oil or oil for water
cooled motors). In case of non-
observance, the motor may be
damaged and the guarantee will
be invalidated.
1. Mix petrol and motor oil in the fuel
mixing canister included with the sup-
ply (31):
- fill petrol (Gas) up to the "585.37"
mark.
- fill two stroke cycle engine oil (Oil)
up to the "600" mark.
- close the container and carefully
shake it.
96
2. Unscrew the filler cap and pour the
fuel mix into the petrol tank. Wipe off
petrol residues around the filler cap
and close the filler cap.

Operating the leaf blower

Danger of injury.
Wear suitable clothing and
work gloves when working with
the device. Make sure that the
device is functioning properly
before every use. Make sure that
the collection bag and the tube
are assembled correctly and the
carrying strap is adjusted cor-
rectly for work.
Note noise protection laws and lo-
cal regulations.
After switching off the device,
the impeller wheel continues to
rotate for some time. Danger of
injury due to rotating tool.

Start the motor

Start the engine at least three
meters from where you refu-
elled.
Before switching on device, make
sure it is not in contact with any
objects. Ensure stable positioning.
The device can only be switched
on if the entire blower / suction
tube is correctly mounted.