Sliding Base/Fence Extension - Skil 3800-02 Instrucciones De Funcionamiento Y Seguridad

Basic Saw Operations

Sliding Base/Fence Extension

Extend and use sliding base/fence when
!
WARNING
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6") spacing
from hand to saw blade.
Sliding Base:
Loosen the thumbscrew 1 in sliding base channel
1.
(Figure 23).
Slide sliding base/fence 2 to the desired position.
2.
Tighten thumbscrew 2.
3.
Sliding Fence:
1. Unlock the fence locking lever 3 (Figure 24).
Slide fence to proper position 4.
2.
3. Relock fence in place.
4. Move the head assembly to check clearance with fence.
During transportation, sliding base and
!
CAUTION
fence should always be secured in the full
in position.
Stop Block:
Stop block can be used to make repetitive length cuts.
1. Attach stop block 5 to extension rail 6 (Figure 25).
2. Loosen thumbscrew 7 on backside of stop block 5.
3. Slide stop block to desired length of cut.
4. Tighten thumbscrew.
Note: Stop block can be stored by loosening knob and
flipping stop block.
All manuals and user guides at all-guides.com
50
FIG. 23
FIG. 24
FIG. 25
5
7
6
2
1
4
3