Uline H-2171 Instrucciones De Ensamblaje página 3

1 PEDESTAL, 1 LEG ASSEMBLY
LEG ASSEMBLY
1. Insert adjustable feet into leg and slide into place.
Make sure that three holes are showing near the
bottom of the leg. This will give your leg a height of
32⁄". (See Figure 8)
NOTE: If desired, insert locking tabs through
legs and adjustable feet to lock feet into place.
Figure 8
2. Align bracket to outside of each leg and secure
using two bolts, two lock washers and two nuts per
bracket. (See Figure 9)
NOTE: Do not tighten bolts.
NOTE: Brackets must be facing same direction.
Figure 9
PAGE 3 OF 18
WOOD OR LAMINATE TOP ASSEMBLY CONTINUED
Adjustable Feet
3 Holes
Lock
Washer
Leg
Bolt
Nut
Bracket
MOUNTING WOOD OR LAMINATE TOP TO LEG
1. Place tabletop on a smooth, non-marring surface
with top side facing down.
2. Choose which side the leg will be mounted to. Using
twelve #14 x 3/4" hex head slotted wood screws,
attach leg to the underside of the top through
pre-drilled holes. (See Figure 10)
NOTE: Tabletop does not include pre-drilled
holes for inner part of leg bracket.
Tabletop
Figure 10
MOUNTING WOOD OR LAMINATE TOP TO PEDESTAL
1. Partially insert four #14 x 3/4" hex head slotted
wood screws into pre-drilled holes in top, leaving
approximately 1/8" between top and screw heads.
Use holes located 6½" from the front and back
edges, 13½" apart. (See Figure 11)
Figure 11
Wood
Screw
Holes Not
Pre-drilled
1120 IH-2171