Pedestal Assembly - Uline H-2171 Instrucciones De Ensamblaje

MOUNTING TOP WITH LEG TO PEDESTAL
1. Remove top two drawers or open cabinet door.
2. Set top assembly onto pedestal, placing screw
heads into keyhole slots, and slide forward.
(See Figure 12)
NOTE: Leveling feet on pedestal can be
adjusted to level the tabletop.
Figure 12

2 PEDESTAL ASSEMBLY

NOTE: For pedestal workbench featuring
1 pedestal and 1 leg assembly, see page 5.
TABLETOP PRE-ASSEMBLY
1. Place Tabletop on a smooth, non-marring surface
with top side facing down.
2. Bolt two channels to holes approximately 14⁄" from
either end of top using four 1/4"-20 x 5/8" bolts.
(See Figure 14)
Figure 14
14⁄"
NOTE: Nine threaded inserts are provided in
each channel.
PAGE 4 OF 18
WOOD OR LAMINATE TOP ASSEMBLY CONTINUED
STEEL TOP ASSEMBLY
14⁄"
3. Position top so that ends of top are flush with cabinet
sides and tighten all screws. Replace drawers or
close cabinet door.
Figure 13
4. Assembly is completed. (See Figure 13) Check all
nuts, bolts and screws for tightness. Adjust pedestal
leveling feet if needed.
3. Insert two 1/4"-20 x 5/8" bolts into threaded inserts in
each channel. Do not fully tighten. Leave about 5/8"
between channel and bolt head. (See Figure 15)
5/8"
Pedestal
Side
Figure 15
MOUNTING STEEL TOP TO PEDESTAL
1. Remove top two drawers or open cabinet doors.
2. Place cabinets squarely 30" apart for 60" tops or
42" apart for 72" tops.
Completed
Assembly
1120 IH-2171