Maintenance; Programmed Maintenance - Sistem-Air JOLLY Manual De Instalación, Uso Y Mantenimiento

BEFORE CARRYING OUT ANY MAINTENANCE OPERATION, ALWAYS
UNPLUG THE SUCTION UNIT FROM THE POWER SUPPLY AND CHECK
THAT THE RED START PUSH-BUTTON IS SWITCHED OFF. ALWAYS WEAR
PROTECTION GLOVES AND GOGGLES.

6.1 Programmed maintenance

In order to keep the system perfectly operating and to avoid possible mechanic trouble,
the user must overhaul the whole system at precise time intervals.
The JOLLY and JOLLY CONTACT suction units are equipped with a maintenance
control system.
In particular, the system indicates when the dust bag must be replaced by means of a
red led assembled on the front side of the suction unit.
IMPORTANT ! = The dust bag must be replaced if the red led remains lit up when
the unit is activated but does not suck.
- Periodically clean the motor filter with running water. Wait until the unit is perfectly
dry before assembling.
- Periodically check that the exhaust air extension outside the wall is not covered or
obstructed.
- Periodically clean the external casing of the suction unit using a smooth cloth dampened
with water and some neutral soap.
- Attention : Be sure to use only water or water with neutral soap when cleaning
the suction unit. Wait until the unit is perfectly dry prior to start it.
Jolly-Jolly Contact 01-04/01
Installation, use and maintenance guide

6 - MAINTENANCE

-ATTENTION-
23