Description Of The Appliance - ARIETE 6248 Manual De Instrucciones

Ocultar thumbs Ver también para 6248:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
SUGGESTIONS
This appliance is not designed to replace an iron. Before you start to use the appliance check the instructions
on the fabric label. If you are not aware of the composition of the fabric of the garment to work, search for a
point of the fabric that is not visible. Make a test in this point.
Do not use the appliance on silk or velvet fabric. Some garments are ironed well upside down or from the
bottom upward.
If you iron in very low position, close to the floor, it is necessary to occasionally raise the steam dispenser to
allow the condensate to fall back into the boiler.
If the nozzles begin to be clogged, you will hear a gurgling noise.
For harder and thicker garments it is necessary to move the steam dispenser several times on them.

DESCRIPTION OF THE APPLIANCE

A - Steam nozzle
B - Dispenser support
C - Telescopic rod
D - Telescopic rod adjustment hook
E - Power cord
F - Rod connection
G - Front swivel wheels
H - Base with boiler
I - Steam pipe connection
J - Steam pipe
Technical and identification data
The plate below the base contains the following data:
• manufacturer and CE marking
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• electrical power consumption (W)
• assistance toll-free phone number
When ordering at Authorized Service Centers, indicate the model and serial number.
INSTRUCTIONS FOR USE
Assembling
Warning!
Before using the appliance for the first time remove any labels and protections from the dispenser
support.
Remove the components from the box. Position the appliance on the ground on a horizontal surface.
Open the rod adjustment hook (D) and extend the telescopic rod to the desired level (Fig. 2).
Open the specific hook and insert the rod into the joint on the base (Fig. 3).
Close the hooks again to lock the rod into place.
Install the dispenser support (B) in the upper part of the rod (Fig. 4).
Connect the steam tube (J) to the base (Fig. 5). Screw the connection (F) in the direction indicated by the arrow.
Position the steam dispenser on the support (Fig. 6).
14
K - Handle
L - Power switch with indicator light
M - Steam adjustment knob
N - Tank cap
O - Water tank
P - Boiler drain cap
Q - Foldable hanger with garment pliers
R - Brush accessory and for trousers creases
S - Glove

Publicidad

Tabla de contenido
loading

Tabla de contenido