Publicidad
Step 2： Open the battery compartment of weather station. Insert 2 x AAA LR06 batteries (not included)
into the weather station.Observe the correct polarity. The red LED will flash during transmission. Close
the battery compartment of weather station.
Restart: If there is no outdoor temperature and humidity data after 3 minutes, remove the batteries
from station and out sensor for 15 minutes then return to step 1above.
Power On：
1. Display full segment for 3 seconds.
2. The weather station starts searching wireless sensor via 433MHZ.
3. If outdoor temperature is not displayed after 3 minutes, hold the "CH" button on the main until to
search for outdoor sensor.Then press "TX" button on the sensor to send signal.If it still does not
receive the outdoor temperature ,remove the batteries from transmitter and go back to step 1 of the
set up.
Sensor ReceptIon
Press and hold the "CH" button for 3 seconds to search for the sensor .
The strengh signal icon will flash utill the sensor signal is received for 3 minutes if no available.
RF signal icon：
Adding additional sensors：
1. Make sure channel 2 or 3 is displayed on the weather station.Press the "CH" button to change
channels on the weather station.
2. Make sure the channel selector switch the sensor 2 or 3 position.
3. Once the channel numbers on the weather station and sensor are the same.Proceed by opening
the battery cover at the back of your wireless sensor and insert 2XAAA new alkaline batteries to the
battery compartment.Replace the battery cover.
4. Press and hold the "CH" button for 3 seconds and your weather station will receive the data signal
from the outdoor transmitter in a few seconds.
5. Place your outdoor transmitters in a dry and shaded area once the weather station receives the
data of this sensor.
-
+
EN 3
AA +
AA
-
-
AAA +
+
AAA -
Publicidad
