Drive Medical PreserveTech 12011KD-1A Manual De Instrucciones página 3

7. To assemble backrest, insert pole into backrest
support by depressing push pin and sliding into
receptacle. Repeat for second pole (Figure 5).
figure 5
NOTE: Back support is reversible to accommodate
left or right tub entry. You can also change the seat
depth of your transfer bench by pushing the pins
under the seat and sliding the tubes forward until
the pins lock into place.
8. Place legs with suction cups into bath tub.
Item # 12011KD-1
precautions
Weight Capacity: 400 lbs / 181 kg
1. Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.
2. Make certain that the height adjusting snap but-
tons fully protrude through the same respective hole
of each leg extension. This will ensure that the leg
extensions are securely locked in position and an even
height is achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.
6. DO NOT stand on chair.
NOTE: To maintain the beauty of the original finish, clean
with mild soap and rinse with warm water. Wipe bath seat
dry after each use.
adjusting leg height
1. Before use, adjust height of each leg to your specific
needs, making sure all legs are at the same height.
When desired height is reached, lock legs into place
by aligning buttons into proper holes.
NOTE: Make sure all legs are set to the same height.
2. To be sure legs are locked into place, push down or
pull up on legs.