Starting The Hedge Trimmer - Toro 51494 Manual Del Usuario

battery. When ready to use again, charge the battery pack
until the LED indicators turn green.

Starting the Hedge Trimmer

1. Remove the protective cover from the cutter blades
1).
WARNING
The hedge trimmer blades can cause cuts or
amputation.
Be careful when handling the hedge trimmer with
the protective cover removed.
1. Protective cover
2. Align the tongue of the battery pack with the cavity in the
handle housing (Figure
1. Auxiliary handle
2. Lock switch
3. Trigger
3. Grasp the trigger handle
4. Push the battery pack into the handle until the latch locks
into place.
Important:
The battery pack is not fully charged
when it is purchased. Before using the hedge trimmer
for the first time, place the battery pack in the charger
charge until the LED indicators turn green. Make sure
to read all safety precautions. With regular use, it will
need shorter charging time. If storing for a prolonged
period of time, remove the battery. When ready to use
again, charge the battery pack until the LED indicators
turn green.
Figure 1
2).
Figure 2
4. Tongue
5. Latch
(Figure 2)..
5. Place one hand on the trigger handle. Place the other hand
on the auxiliary handle
6. Slide the lock switch backwards, towards you, then squeeze
the trigger switch to turn on the hedge trimmer
The trimmer will stay on as long as the trigger switch is
squeezed. Lock-off switch may be released once hedge
(Figure
trimmer is running
g016138
g016139
4
(Figure 2).
(Figure 2).
(Figure 2).