HDMI Ultra-Slim HDBaseT + RS232 And IR Over Cat Extender Box Receiver - 4k 60hz
Features
Supports HDMI 1.4 and HDCP 2.2 compatibility
•
Supports resolutions up to 4K@60 4:2:0 8bit
•
Via a Cat 6a/7 cable, transmits 4K@60Hz 4:2:0 8bit signal up to 40m/130ft and transmits
•
1080P signal up to 70m/230ft
Via a Cat 5e/6 cable, transmits 4K@60Hz 4:2:0 8bit signal up to 35m/115ft and transmits
•
1080P signal up to 60m/200ft
Supports bi-directional PoC
•
Supports bi-directional IR pass-through over HDBT
•
Supports bi-directional RS232 pass-through over HDBT
•
Supports CEC pass-through over HDBT
•
Slim profile, space saving and easy-to-install
•
Mounting Bracket Installation
Note: Before installation, please ensure the unit is disconnected from the power source.
1. Remove the screws from one side panel of the unit.
2. Attach the installation bracket to the enclosure using the screws that were provided in the
package separately. The bracket height can be adjusted up/down or bracket face up or down.
3. The bracket is attached to the enclosure as shown.
4. Repeat steps 1-2 for the other side of the unit.
5. Attach the brackets to the surface you want to mount to using screws (not included).
Wiring
Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect an HDMI source (such as PC, Blu-ray player, Apple TV, 4K media player, etc) to the HDMI IN of the transmitter using an HDMI cable.
2. Connect an HDMI display device (such as TV, projector, LED/LCD display) to the HDMI OUT of the receiver using an HDMI cable.
3. Connect HDBT OUT of the transmitter to HDBT IN of the receiver using a Cat 5e/6/6a/7 cable.
4. Connect the IR emitter to IR OUT of the transmitter/receiver, and the IR receiver to IR IN of the receiver/transmitter; secure the IR emitter head
over the center of the source device/display IR window.
5. Connect the power adapter provided to either the transmitter or receiver and lock the power adapter to the power connector by twisting the
locking collar clockwise.
6. Power on all attached devices.
When all is set, check if all LED indicators on the transmitter and receiver are normal to ensure installation is successful. For LED indication, please
refer to Panel Description section.
Package Contents
•
•
•
•
•
•
•
•
3
1 x Receiver
1 x 18V 1A Power Adapter
1 x IR Emitter
1 x Broadband IR Receiver (30-50 KHz)
2 x Double sided tape for IR Emitter
and Receiver
1 x 3.5mm 3-Pin Phoenix Connector
2 x Mounting Bracket (with screws)
1 x Manual
(us)
(us)
(us)