Answering A Phone Call; Making A Phone Call - Nolan N-Com Intercom E-Box Kit Seguridad E Instrucciones

NOLAN nCOM intercom 0025

5.1. Answering a phone call

Answering from the helmet
- The cell phone receives an incoming call (buzz that acts as telephone ringing; the type of buzz depends on the cell phone).
- Stop your vehicle in a suitable place in compliance with Traffic Regulations.
- Press the "on" key and keep it pressed for 2 seconds (two buzzes will be heard in succession)
Note: Not all cell phones allow for a call to be answered directly from the helmet. This depends on the software installed in
the phone and not on the N-Com system. In case your cell phone does not allow you to answer directly from the helmet,
use the automatic answer function (see below).
Note: Not all mobile phones send a ringing tone to the helmet (and to every type of earphone connected). In this case, turn
on the cell phone vibration mode to be notified of an incoming call.
Note: If two helmets are in intercom mode at the time of an incoming call, connection to the passenger's helmet is cut off.
At the end of the phone call, the intercom mode can be turned back on by pressing key "
buzz in the earphone).
- Press key "on" and keep it pressed for about 2 seconds to end the call (double buzz in the earphone).
Automatic answer
- Preset your cell phone for the automatic answering function when it is connected to an earphone.
- When turning on the system, if you are not connected to the passenger, briefly press the "on" key so as to preset the
system to using the cell phone with automatic answer.
- When a call comes in, the cell phone automatically answers and you can start talking.
Note: If you are connected to the Passenger in intercom mode, the passenger will also be able to hear the phone
conversation. To disconnect the passenger, briefly press the "on" key when a call comes in. At the end of the phone call,
you can switch back to the intercom mode by pressing key "
in the earphone).

5.2. Making a phone call

- Stop the vehicle in a suitable place in compliance with Traffic Regulations.
- Disconnect the passenger by briefly pressing key "on".
- Make the phone call as you would normally with your cell phone. After the call is sent from the phone, communication is
switched directly to the helmet.
- At the end of the phone call, you can switch back to the intercom mode by pressing key "on" for about 2 seconds (double
buzz in the earphone).
23-05-2006 16:22 Pagina 26
L L
26
L L
" for about 2 seconds (double
"and keeping it pressed for about 2 seconds (double buzz
ENGLISH