Attaching/Detaching The Lens - Panasonic Lumix H-FS14140 Manual Del Usuario

6 O.I.S. switch
When the lens is attached to the camera the
stabiliser function is set to activate if the O.I.S.
switch is set to [ON].
≥ We recommend setting the O.I.S. switch to [OFF]
when using a tripod.
≥ The stabiliser function may not be effective in the
following cases.
– When there is a lot of jitter.
– When the zoom magnification is high.
– When using the digital zoom.
– When taking pictures while following a moving
subject.
– When the shutter speed becomes slower to take
pictures indoors or in dark places.
Note
≥ When flash recording with a close subject, the
light of the flash will be blocked by the lens and
part of the picture may be dark. Check the
distance from the subject when recording.
≥ If you zoom after focusing, focusing errors may occur.
After zooming, please perform the focusing again.
6
VQT4Y54

Attaching/Detaching the Lens

≥ Refer also to the camera's
operating instructions for
attaching and detaching the lens.
≥ Check that the camera is turned
off.
≥ Remove the lens rear cap from the lens.
∫ Attaching the Lens
Align the lens fitting
marks A on the
camera body and the
lens and then rotate
the lens in the
direction of the arrow
until it clicks.
• Do not press the lens release button B when
you attach a lens.
• Do not try to attach the lens when holding it at an
angle to the camera body as the lens mount may
get scratched.
• Check that the lens is attached correctly.
• Be sure to remove the lens cap when recording.