Installation; Electrical Connections - Hoshizaki DIM-40DE-HC Manual De Instrucciones

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the
manufacturer cannot be held responsible.
The appliance is only to be installed in locations where it can be overseen by trained
personnel.
* Place the ice dispenser in the selected permanent location.
* Adjust the four legs on the bottom (adjustable up to 4.5 cm) to have the ice dispenser perfectly horizontal. Use a spirit level.
* Secure the ice dispenser to the wall by using the braces (accessories) and mounting screws (not supplied). Bend the braces
according to the installation condition.

6. ELECTRICAL CONNECTIONS

This ice dispenser requires an earth that meets the national and local electrical code
requirements.
To prevent possible severe electrical shock to individuals or extensive damage to the unit, install
a proper earth wire to the ice dispenser.
Disconnect the main power supply before any maintenance, repairs or cleaning is undertaken.
* This appliance requires a separate 220 - 240VAC, 10A supply. The electrical supply must be protected by a suitable circuit
breaker.
* The main control box fuse is rated at 5A and should only be replaced by a qualified service engineer.
* Usually an electrical permit and services of a licensed electrician are required.
CAUTION
Adjustable Leg
WARNING
THIS APPLIANCE MUST BE EARTHED
Brace
Mounting Screw
5
ENGLISH
Machine
Screw (M4)