Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
TROUBLESHOOTING
- If the screen shows HI :
Voltage of the tested battery is over 15.00V & too high for 12V battery. BT 12 V won't work under
this situation. Please re-check if the tested battery is 12Volts.
- If the screen shows Lo : Voltage of the tested battery is under 7 Volts. Testers won't work under
this situation. Please recharge the battery & retest. If reading is the same, the battery should be
replaced immediately.
- If the screen shows blank :
The voltage of the tested battery is too low to serve the BT 12 V. Please recharge the battery
retest. If reading is the same, the battery should be replaced immediately. Or the clamps are
connected inversely. Please check & re-connect it.
- The screen flickers or shows ---- :
The voltage is unstable. Please recharge the battery and retest. If reading is the same, the battery
should be replaced immediately.
You should check whether any accessories have been left on and then charge and retest
the battery. If accessories have not been left on, the battery is to be replaced

Technical Data

Voltage
Voltmeter
Cold start current: SAE:
DIN:
IEC:
EN:
CA(MCA):
Dimensions (LxWxH):
Cable length:
Weight:
Operating temperature:
12V
7-15V
200~1200 CCA
110~670 CCA
130~790 CCA
185~1125 CCA
240~1440 CA(MCA)
120 x 70 x 20mm
40cm
250g
0ºC (32ºF) to 50ºC (122ºF) (ambient temperature)

Publicidad

Tabla de contenido
loading

Tabla de contenido