Side Handle - DeWalt DW562 Manual De Instrucciones

DW562/329528-02 5/7/02 11:34 AM
permanent eye damage.
• Always use the side handle supplied with the tool. Keep a firm
grip on the tool at all times. Do not attempt to operate this tool without
holding it with both hands. Operating this tool with one hand will result
in loss of control. Breaking through or encountering hard materials
such as re-bar may be be hazardous as well.
• Do not use chisels in any of the rotation modes. Chisels may jam
causing loss of control.
• Wear gloves when handling hammer bits and tools. Hammer bits
and tools get hot during operation. Gloves and frequent rest periods
will reduce risk of vibration damage to hands and arms
• Keep hands and body from between the tool and wall or post, etc.,
to avoid being crushed by the tool should it twist unexpectedly if the
bit binds .
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• The label on your tool may include the following symbols.
V ........................volts
A ........................amperes
Hz ........................hertz
W ........................watts
min ........................minutes
Page 3
3
FIGURE 1
........................alternating current
........................direct current
n o
........................no load speed
........................Class II Construction
.../min ......................revolutions per minute
BPM ........................beats per minute

Side Handle

CAUTION: Always use side handle and hold hammer with both
hands. A side handle is supplied with this hammer. It clamps to the
front of the gear case as shown in Figure 1 and can be rotated 360˚
to permit right or left hand use. The side handle can be tightened by
rotating the black plastic portion of the side handle clockwise and
loosened by rotating it counterclockwise.
Switch
To start hammer, depress the trigger switch (Figure 2). To stop
hammer, release the switch. To lock the trigger switch in the ON
position for continuous operation, depress the trigger switch and push
up the locking button. The tool will continue to run. To turn the tool OFF,
from a locked ON condition, squeeze and release the trigger once.
Before using the tool (each time), be sure that the locking button